Custom Ramp Basin Design

Project Name *

Project name is required before continuing.

Choose Model:

Select the Ramp basin model to customise your design.

Number of Basins:

Taps (H) and wastes are counted per basin. Basins are split evenly across the bench length.

Standard Basin Dimensions

G Front Edge Inset: 20 mm 40 mm

Basin Position: Centre Left Right

Right Edge (from left):

Bench Dimensions A (Length): B (Width): C (Height): D (Inset Sides): E (Back Edge Inset):

Wall mounted taps

Taps mount on the wall — no holes drilled in the bench. E becomes adjustable (50–145mm) and tap holes are hidden on the spec sheet. Dryer backplates are still shown.

Gap Between Basins: Basin Width Left and Right (auto): H (Number of Taps): per basin

Tap distance from basin side edge:

Minimum 200mm from the basin's side edge

Tap distance from Basin Back Edge:

Wastes: per basin

Override: single waste only

Backplate, tap & waste placement Backplate offset from tap (mm):

Backplate side: Left of tap Right of tap

Left Right

Gap between wastes (mm): Fine-tune centre waste (mm, + right / − left):

Wastes are spaced evenly about the basin centre by the gap above. With an ODD number of wastes, one sits on the basin centre — use "Fine-tune centre waste" to nudge just that one (+ right / − left) for plumbing access; the others stay evenly spaced from the centre. With an EVEN number there is no centre waste, so the fine-tune has no effect. Use "Set … individually" below to nudge any waste on its own. On a multi-basin bench these settings apply within each basin (wastes are counted per basin).

Set backplates / wastes individually

Signed mm (+ right / − left). Backplate values are measured from each tap; waste values nudge each waste from its auto position. Leave a field blank to use the default.

Soap Dispenser/s Required

Soap : Tap Ratio 1 : 1 (per tap) 1 : 2 (per pair) Every gap

Side (relative to tap hole/s) Left Right

Hole Diameter (mm): Distance from Tap Hole/s (mm):

Distance from Basin Back Edge (mm):

Distance into the E back edge zone from the basin edge.

Dryer Hole/s Required

Dryer : Tap Ratio 1 : 1 (per tap) 1 : 2 (per pair) Every gap

Side (relative to tap hole/s) Left Right

Hole Diameter (mm): Distance from Tap Hole/s (mm):

Distance from Basin Back Edge (mm):

Distance into the E back edge zone from the basin edge. A backplate is fitted behind each dryer hole.

Backplate Side (relative to dryer hole) Left Right

Backplate Offset from Dryer Hole (mm):

Default 90mm. Clamped so the backplate edge never crosses the back edge brackets (110mm from each bench end).

Set dryer backplates individually

Signed mm (+ right / − left), measured from each dryer hole. Leave a field blank to use the default offset/side above.

No backplate is fitted on basins under 300mm tall (the dryer hole is still included).

F (Top Depth Inset):

Finish Matte Gloss

Colour: White

Quantity

Item added to your cart

Custom Ramp Basin Design

Steps to customise your basin: